> >>SENSORE DI PIOGGIA - GRAVITY STEAM SENSOR - ARDUINO COMPATIBILE
SENSORE DI PIOGGIA - GRAVITY STEAM SENSOR - ARDUINO COMPATIBILE Visualizza ingrandito
Precedente Successivo

SENSORE DI PIOGGIA - GRAVITY STEAM SENSOR - ARDUINO COMPATIBILE

DFRSEN0121

Nuovo prodotto

SENSORE DI PIOGGIA - GRAVITY STEAM SENSOR - ARDUINO COMPATIBILE

Maggiori dettagli

24 Articoli

3,05 €
IVA inclusa

Scheda tecnica

Peso Kg.0,050

Dettagli

SENSORE DI PIOGGIA - GRAVITY STEAM SENSOR - ARDUINO COMPATIBILE

WIKI PAGE    

This is a steam(water)sensor from DFRobot. This steam sensor can be connected to the Arduino IO Expansion shield directly. The output voltage will increase when the humidity of the sensor surface goes up.
 
Notice:The new version of analog sensor port pin mapping has been changed as the following two features.Please check thetips for changing sensor cable pin mapping while using the I/O Expansion shield. We will continue to update. For the inconvenience caused, please understand.

 


Warning: The connector is not waterproof, please be careful not to put the connector directly in water. 
APPLICATIONS
  • Simple rain detector
  • Cheap steam level switch
  • Touch sensor based on humidity

SPECIFICATIONS

  • Power supply: 3.3v or 5v
  • Output voltage signal: 0~4.5v(@5v) or 0~3.0v(@3.3v)
  • Pin definition:
  • Analog output(Blue wire)
  • GND(Black wire)
  • Power(Red wire)
  • Size: 30x20x6mm (0.18x0.79x0.24")

I clienti che hanno acquistato questo prodotto hanno comprato anche: